![]() b) Now click the "Synchronization Tool" button under the "Input Files" section, and set its "Input File".The main preview should now seek to the exact start of the lap/run for the primary data. This will typically be the "Lap 001" line. Click on the line that shows the lap you want to use. a) Click the "Laps" button at the top, set its "Input" selection to your primary data file.8) Synchronize the second data file so that the start of its run or selected lap matches that of.c) Note that the "Draw Map" checkbox may be automatically set if you make changes, so you’ll want toīe sure to go un-check it on that second (topmost) track map.Make the same changes to the other track map display so that they stay in proper alignment. b) If you make other changes to either track map display (other than color), you will usually need to.On top of it, and this one’s "Draw Map" box should not be checked. a) To confirm this, the primary data’s track map will be on the bottom (and will be shown lower in theĭisplay Objects list), and it will have its "Draw Map" box checked.It will still appear to be on a map plot due to being aligned on top of the other map That will make this display only show its vehicle position icon alone, and not 7) In the properties box for the second track map, change the "Vehicle Position" color to something different,Īnd then un-check the "Draw Map" box.6) On the main preview screen, click and drag the second track map to position it on top of the first track map.Īssuming that both runs/laps covered the same geographical area, and had good GPS data, they should align easily.You may also want to change its label to be more clear that it’s the "Input" selection to your second data file. 5) Double-click on this newly-created second track map display to open its properties box, then change its.4) Click on the Track Map display object, then press the "Duplicate" button to make a copy of it.a) If you are intending to overlay another lap from the same input file, right-click on it in the "Input Files" list and select "Duplicate", then change its name to be more unique.3) Add the second data file to your project, and cancel out of the template menu that appears, so that no displays.c) Do not use the Zoom or Rotate options, as they will not align properly.b) If you made the map full screen or very large, set the "Resolution" option to "Higher" or "Extreme" for increased quality.a) You may want to change the "Vehicle Position" icon to "Arrow 1", as this will help make each run/lap more visible.2) Double-click on the Track Map display object to open its properties box, and customize it to your liking.1) Setup a RaceRender project with your primary data file, like normal.This requires them to both have been recorded on the same race This is a step-by-step guide for displaying two vehicles (or two different runs/laps) How To: Show Two Vehicles or Two Runs/Laps on the Same Map RaceRender 3 - Documentation - How To: Show Two Vehicles or Runs/Laps on Same Map
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |